F3 E1 error code whirlpool washer repair

F3 E1 error code whirlpool washer repair

If your front-loading Whirlpool washer is showing the F3 E1 error code, this is very likely the problem.

This small part here is the pressure switch. When it fails, the washer can’t correctly sense the water level—and that’s what triggers the error.

The good news?

This is a cheap part, an easy DIY fix, and you don’t need any special skills to do it.

Here is the recommended replacement on Amazon, so you can grab the correct one right away.

Let’s get into the fix.

F3 E1 error code whirlpool washer repair

Step-by-step Section (whirlpool washer F3 E1 error code repair video posted on YouTube..see link after the following steps)

This is important—disconnect the washer from power before you do anything else. Safety first.

Step one:

Go to the back of the washer and remove the screws at the rear.
You can use an impact driver, or even a simple quarter-inch nut driver—either one works just fine.

 

Step two:

Remove the rear panel.

Once that’s off, look at the right rear corner.

You’ll see the pressure switch—it’s a small component with a rubber tube attached to it.

 

Step three:

Now we’re going to drain any water from the filter.

Place a pan or tray underneath, then slowly twist the filter cap.

Don’t force it—let the water drain gradually.

Once most of the water is out, you can remove the cap completely.

Take a moment to clean the filter, removing any dirt, lint, or hair you see.

 

Next, disconnect the hose from both ends and check for any blockages or debris.
If you find anything, remove it.

You can also gently blow air through the tubing to make sure it’s completely clear.

Now, twist and pull out the pressure switch.

You don’t need much force here—it should come out easily.

Grab your new pressure switch, and install it the same way the old one came out.
If it helps, this is a good time to refer to a photo you took on your phone before disconnecting anything.

Reconnect the tubes, make sure everything is seated properly, and reinstall the panel.

And that’s it.

Before installing the new one, here’s a very important step:
make sure there is no trapped air in the hose before reconnecting it to the pressure switch.

Your washer should now be error-free and working like new again.

Order the replacement part using this link, do the repair yourself, and save money on a service call.

If this post helped you, please leave a comment, and I’ll see you in the next one.